The 1979 Freightliner Coe has 4 NHTSA recall campaigns affecting an estimated 40,462 vehicles. Recall repairs are always free at any authorized dealer. Last updated July 5, 2026.
THE STEERING GEAR MOUNTING BRACKET WELDS MAY CRACK UNDER CERTAIN STEERING LOAD CONDITIONS.
STEERING CONTROL WOULD BE ADVERSELY AFFECTED WITHPOTENTIAL FOR LOSS OF TRUCK CONTROL AND AN ACCIDENT.
REPLACE STEERING GEAR MOUNTING BRACKET WITH A REDESIGNED BRACKET.
CORROSION OF THE GRABHANDLE AT ITS MOUNTING SURFACE MAY LEAD TO CRACKING OR LOSS OF STRENGTH.
FAILURE OF GRABHANDLE DURING USE COULD RESULT INPERSONAL INJURY.
REPLACE GRABHANDLE AND ITS FASTENER WITH IMPROVED GRABHANDLE; ALSO, INSTALL GASKET BETWEEN THE HANDLE AND AIR STARTER RESERVOIR.
ON INVOLVED VEHICLES, THE CONNECTION BETWEEN THE STEERING CONTROL SHAFT AND THE INPUT SHAFT ON THE STEERING GEAR BOX MAY BE DEFECTIVE. THE YOKE ON THE SHAFT MAY LOOSEN, ALLOWING THE SPLINED SURFACES ON THE YOKE AND SHAFT TO WEAR. CONTINUED OPERATION MAY RESULT IN WEAR AND EVENTUAL ROTATIONAL SLIPPAGE OF THE JOINT.
THE YOKE WILL BE REPAIRED OR THE YOKE AND INPUT SHAFT WILL BE REPLACED, IF NECESSARY.
THE PARK/RUN VALVE IN THE WINDSHIELD WIPER MOTOR MAY STICK IN THE PARK POSITION. AN OUT OF BALANCE DIMENSION IN THE CYLINDER RESULTED IN AN UNDERSIZED BORE WHICH MAY CAUSE THE PLUNGER TO STICK. THEREFORE, THE WIPER MOTOR MAY FAIL TO START.
THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE WINDSHIELD WIPER MOTORS FOR CONVENTIONAL MODELS. ALSO, THE CONTROL VALVES ON THE DASH WILL BE REPLACED AT NO COST TO OWNER.
Recall, complaint, and investigation records from official NHTSA datasets (FLAT_RCL, FLAT_CMPL, FLAT_INV), synced weekly. Counts reflect NHTSA records for the 1979 Freightliner Coe as of July 5, 2026. Complaint narratives are consumer-submitted and unverified. This page contains ads and affiliate links. Full methodology.