1999 Chrysler Sebring Recalls

Recalls on record Updated July 2026

The 1999 Chrysler Sebring has 1 NHTSA recall campaign affecting an estimated 393,796 vehicles. Recall repairs are always free at any authorized dealer. Owners have filed 231 complaints with NHTSA, most often about the power train. Last updated July 5, 2026.

Recall campaigns

SUSPENSION 00V421002 2000-12-18 393,796 affected
Defect

VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.

Consequence

THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH. THIS CAMPAIGN SUPERCEDES MMC'S PREVIOUS SAFETY RECALL CAMPAIGN, SEE 99V-066.

Remedy

DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT…

Complaints by component

POWER TRAIN:AUTOMATIC TRANSMISSION
17
1crashes1injuries
STRUCTURE:BODY:DOOR
14
1crashes
WHEELS:RIM
11
VEHICLE SPEED CONTROL
10
6crashes1fires3injuries
TIRES
9
AIR BAGS:FRONTAL
8
8crashes1fires2injuries
ELECTRICAL SYSTEM
7
1fires
SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP
7
2crashes1injuries
STRUCTURE:BODY:DOOR:HINGE AND ATTACHMENTS
7
SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT
7
1crashes1injuries
Total complaints231

What owners report

Verbatim reports filed with NHTSA, lightly edited for readability and with personal information removed.

“Tl* the contact owns a 1999 chrysler sebring. Prior to purchasing the vehicle, the contact was not informed by the dealer that the vehicle needed extensive repairs. The contact requested reimursement. The manufacturer was not notified. The failure mileage was 200,000.”

ELECTRICAL SYSTEM · reported 2016-09-24

“Tl* the contact owns a 1999 chrysler sebring. Prior to purchasing the vehicle, the contact was not informed by the dealer that the vehicle needed extensive repairs. The contact requested reimursement. The manufacturer was not notified. The failure mileage was 200,000.”

ENGINE · reported 2016-09-24

“Takata recall my concerns of accidental discharge,the dash light stays on longer than should.”

AIR BAGS · reported 2016-08-23

“Takata recall my concerns of accidental discharge,the dash light stays on longer than should.”

POWER TRAIN · reported 2016-08-23

“Takata recall my concerns of accidental discharge,the dash light stays on longer than should.”

STEERING · reported 2016-08-23

“Tl* the contact owns a 1999 chrysler sebring. While driving in reverse, the vehicle suddenly accelerated to an extremely high speed. The contact crashed the vehicle into the passenger side of another vehicle. A police report was not filed and there were no injuries. The vehicle was not diagnosed…”

VEHICLE SPEED CONTROL · reported 2014-09-06

“Tl* the contact owns a 1999 chrysler sebring. The contact stated that while driving approximately 3 mph, the vehicle became impossible to steer. The vehicle was taken to an independent mechanic who diagnosed that the ball joint was faulty. The manufacturer was notified of the failure. The failure…”

SUSPENSION · reported 2014-03-03

“Purchased a 1999 chrysler sebring convertible for my daughter. The front seat belts were knotted near the seat back rest. Without my knowledge, son and daughter un-knotted the seat belts which retracted all the way in. Both seat belts are now locked and cannot be retracted. Took to a mechanic and…”

SEAT BELTS · reported 2012-06-13

Defect investigations

Investigation PE00007 Opened 2000-02-02 · closed 2000-07-18

DOOR PANEL/GARNISH SEPARATION

ALLEGED THAT THE PLASTIC GARNISH PANELS MOUNTED ON DOORS DETACH FROM THEIR MOUNTINGS, SOMETIMES WHILE THE VEHICLE IS IN MOTION

Investigation PE02082 Opened 2002-11-06 · closed 2003-04-23

SAFETY BELT CINCHING LATCH PLATE

THERE ARE NO INJURIES OR FATALITIES ASSOCIATED WITH THIS ALLEGED DEFECT.WHILE CONDUCTING THIS INVESTIGATION, ODI FOUND THAT THE SUBJECT CINCHES MEET THE LOAD BEARING REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 208, AND THAT MANY OF THE REPORTED FAILURES WERE DUE TO INCORRECT CHILD SAFETY SEAT INSTALLATIONS.…

Sources & methodology

Recall, complaint, and investigation records from official NHTSA datasets (FLAT_RCL, FLAT_CMPL, FLAT_INV), synced weekly. Counts reflect NHTSA records for the 1999 Chrysler Sebring as of July 5, 2026. Complaint narratives are consumer-submitted and unverified. This page contains ads and affiliate links. Full methodology.